Metal Laminate Mounting Options

Letters with no mounting hardware, Letters can be attached to mounting surface with a combination of adhesive or double faced tape .

These posts will require the letters to stand-off the mounting surface approximately 3/8" - 1/2".  Drilling patterns are required for this installation. 

Letters 3/8" and thicker can be drilled and tapped for stud installation.  Specify if studs need to be in line for brick / block mortar joints or rails. 

Stud posts are bonded to letter backs to receive studs or on 3/8" or thicker material, drilled and tapped. These blocks will require the letters to stand-off the mounting surface approximately 3/8" - 1/2". Studs are in line for rails at the distance you specify. Drilling patterns are required for this installation.

Pads are plastic disks on the rear of the letters. Secure the letters to the wall using a split stencil pattern or spacing tape guide and silicone adhesive. Adjustable or flush pads available upon request.

Combination of studs and pads. Stud through a pad on the top portion of each letter, pads only on the bottom portion of each letter.